K0858 Torque-free Valve Ends
Set of 2 - hot and cold are identical
Prevents water from dripping from the end of the spout. Replace if adjusting the handle(s) does not remedy the problem.
Standard for :
- M76 Imperial Four
- M76XL Imperial Four XL
- M59 Imperial III
Will also fit these models after original stems have been replaced with K1078 Hot Valve Assembly and K1079 Cold Valve Assembly:
- M87 Solaric
- M59 Imperial
- M52 Deluxe
Instructions: if Valve End will not come out
Instructions: Older Models
858 x 0858 end 840 x 0840 x 1226 x 1227 x 1228 bibb washer bib washer D1858 DI858 Dl858
Dishmaster in general has always been a whiz at the engineering. These are no different, Perfect Fit, and we were back in business in a few minutes.
I have two units, one in Michigan and one in Florida. I may have to change them out for conventional kitchen faucets because repair parts are too expensive and difficult to obtain. It seems that one and two dollar parts are costing 10 and 20 dollars to replace. You have a monopoly on these units and are pricing yourselves out of the market. The next time I need parts I may just go to Home Depot or Lowes and buy a conventional faucet.
We don't like inflation any better than you do but with our costs increasing daily we eventually have to raise prices to stay in business. If $13 for two repair parts is breaking your budget, you can save by purchasing just the 11/16 x1/2x3/16 O-rings and the 1/4R flat non-beveled bibb washers from you local hardware or home center. A chart of all the O-rings we use on our products is available on our website. https://dishmasterfaucet.com/pages/o-ring-application-chart
best and fast service all it took was one phone call