Spout - M70 & M65

Spout Installation - M70 & M65

The water supply valves need not be shut off but do NOT open the mixer valve until the installation is complete!

Remove Spout Assembly

• Remove short set screw (if applicable) - 2.5mm hex key.
• Remove long set screw - 2.5mm hex key.
• Pull spout straight up to remove - Caution: water will drain from base of spout.
• Seat may have been left in faucet body - make certain it is removed.

Clean Faucet Body

Install Spout

• Apply NSF-61 certified silicone (plumber's) grease to inside surface of faucet body.
• Apply silicone grease to outside surfaces of seat, O-rings and retainer.
• Rotate spout until cross-hole in retainer is aligned with cross-hole in faucet body.
• Lower spout into faucet body, without rotating, until fully seated.
• Use hex key to probe and verify cross-holes are aligned - Very Important
• Screw long set screw into faucet body until seated against spout - Caution: set screw MUST pass through cross-hole in retainer and make contact with spout. Otherwise, water pressure will force the spout out of the faucet body when faucet is in use!
• Rotate long set screw 1/2 turn counter-clockwise.
• Screw short set screw (if applicable) into faucet body until firmly seated against long set screw.