K0292 Venturi Assembly

K0292 Venturi Assembly

Water supply need not be shut off.

Disassemble Spray Tube and Handle

  • Unscrew nut from handle - if pliers are required, pad jaws with a cloth to prevent scratches.
  • Slide nut toward brush to expose bushing
  • Remove bushing
  • Slide handle back along hose and let red button drop out.

Remove Venturi Assembly 

  • Cut hose approximately 3/4” from shoulder of venturi.

Reassemble

  • Slide hose over barbs to shoulder of venturi - it may be helpful to lubricate barbs with small amount of detergent.
  • Rotate handle and hose so that button hole is down.
  • Drop button into button hole.
  • Slide handle over venturi - spring side of venturi MUST be toward button.
  • Lubricate taper tube with NSF-61 certified silicone (plumber's) grease
  • Place nut onto taper tube.
  • Slide bushing onto taper tube and into nut.
  • Slide nut with bushing to shoulder at end of taper tube.
  • Attach spray tube assembly - hand tighten nut.
  • Adjust direction of spray to desired position by rotating spray tube assembly.
  • Tighten nut just firmly enough to hold spray tube in desired position - if pliers are required, pad jaws with a cloth to prevent scratches.