P4255 No-Drip Solution

P4255 No-Drip Solution

Caution: When determining the length to cut, we recommend you cut too long. You can always remove a bit more at a time as you sneak up on the desired length. Dishmaster will not replace product that has been cut too short. If water should leak from the gap between where the spout and the aerator are screwed together you will need to add an additional seal.

QR code


Dishmaster Sapphire Faucets:

  • High Arc Spout - leave length as is
  • Low Arc Spout - cut length to 2-3/4 inches from face of seal
  • Right Angle Spout - cut length to 2-3/4 inches from face of seal


Other brand faucets:

  • Determine high point of the spout
  • Measure from that point the the end of the spout NOT to the end of the aerator
  • Cut to length