SA0226R7 Spout, Straight, Full

Works perfect

Spout replacement on an older dishmaster was described on YouTube and I was able to order the appropriate part from Dishmaster and installed it per the instructions supplied and by watching the video. Nothing could have been simpler. Worked great the first time. I must confess I've repaired this unit several times and instructions were always clear and repair was never a problem.

The replacement of the straight spout went well.

This an upgrade from the current original this a more pleasing experience !
I have used Dishmaster for more than 50 years.

I'm disappointed that the original sprung a leak in the metal, don't think that should have happened. But the replacement is fine so far.

Thanks for your fast shipping and quality products. I received the right parts with fast shipping.

The new spout was so easy to put on. Along with the new face plate it makes the faucet look just like new. I love your thank you card. We've had a Dishmaster since the early 50s when my parents bought this house. Thank you

The new, 8 Inch Straight Faucet replaced the corroded and wobbly faucet with stuck diverter valve in my older Dishmaster Imperial Four perfectly. It looks great and restores full operation to the Imperial Four.

The three (3) items ordered showed up in my US Postal Service delivery on Saturday, October 24, 2020, just when I hoped they would; all in a single package. The two black brushes, silicone grease, and gleaming new chrome spout (without any Cr plating flaws), were packed well and in perfect condition! After applying silicone grease to the O-Ring on the spout's center swivel barrel, and assembling that to the valve manifold; the threaded lock ring engaged the threads immediately. The spout went right on (didn't have to 'wrench' anything on); just snugging up the mounting ring finger-tight! No leaks any more from the spring-loaded, pull-up, diverter rod or the spout swivel area, just as I expected. The spout couldn't have fit any better if I'd made it on a metal lathe and silver brazed it up myself along with the spring-loaded and double o-ring sealed diverter rod and attached black PLS knob. I guess PERFECT WILL JUST HAVE TO DO! Thank you all again. Had the Dishmaster working like new in twenty-minutes.

N.B. - I did notice in the text somewhere on your helpful website on the care required when assembling the R & L vacuum-metallized, molded, PLS hot and cold valve knobs onto their respective valve stems; and that they should be pushed on to their brass stems, engaging what was described in the text as "the knurling." I believe the word you wanted to use would be the brass stem's "splines" (which I think is better than the even the word 'fluted'). The procedure is to rotate the faucet lever CW or CCW such that the water flow is completely shut off (no drips) at the spout, and just before the handle's rotation 'stop' is reached (and not end up over-tightening the valve) placing excessive squeeze on its rubber seal. Knurling is that cross-hatched 'grippy' surface finish treatment rolled onto the brass lock rings using a tool held in the tool post of a metal lath. Lock rings are used to mount the faceplate to the manifold at the H & C valves and PLS housing; and to mount the spout swivel barrel. A very small cutter or endmill would likely be used to make the splines on the knob-end of each valve stem.

Fantastic customer service!!

It's perfect.

Faucet like new again

it is working like it was suppose to when i purchased the faucet in the first place

Item arrived quickly. Well packaged, e mails providing progress of order were appreciated

I bought a new out put spout. Now I have a replacement fixture.
Thanks!!

Have been using Dishmaster for many years. Due to the stuff in our water they wear out every so often. Normal wear-normal replacement. Now working great!!

Good, quick service

Replacement solved my problem!!!