K1235 Hose and Wand Assembly - M76XL
K1235 Hose and Wand Assembly - M76XL
Water supply need not be shut off for this repair. "U' shaped copper tube is not used for this repair.
Remove Hose
- Use 15/32” wrench to hold copper tube assembly nut.
- Unscrew hex nut using 3/8” wrench.
- Remove flared copper from tube with spring.
- Lift wand and remove hose from hose guide.
Reassemble
- Insert small end of straight flared copper tube into small hose section approx 3/4" - apply detergent as lubricant.
- Slide brass tube nut, threaded end first, onto barbed plastic hose tube.
- Insert barbed end of plastic hose tube (apply detergent as lubricant), to shoulder, into large hose section.
- Insert hose down through hose guide and seat wand in hose guide.
- Use 15/32” wrench to hold copper tube assembly nut.
- Attach hex nut using 3/8” wrench.
- Insert flared copper (apply detergent as lubricant) into tube with spring approx 1/2".
Adjust Spray Tube
- Spray tube may be rotated to direct the spray as desired.
- Loosen handle nut - pliers may be required – pad the jaws with a cloth to prevent scratches.
- Adjust direction of spray to desired position by rotating spray tube.
- Tighten nut just firmly enough to hold spray tube in desired position.