FREE SHIPPING to Continental US for All Orders Over $99 . . . No State Sales Tax except IN and MI
0 Cart
Added to Cart
    You have 0 items in your cart
    You have 1 item in your cart

      Tank Assembly

      • U-shaped tube has 2 small holes in its side. One of these holes is at the bottom of the “U”, and the other is near one end of the tube.
      • The end of the tube that does have a hole in the side is attached to the tank lid with the vent tube plug (small thumb tack shaped piece).
      • The end of the tube that does not have a hole in the side is inserted through the hole in the lid of the detergent tank and protrudes from the top of the lid approximately 1 inch.


      • Your Dishmaster will not function properly if tubes are not assembled correctly. Tube-to-tube connections must have minimum overlap as shown and must be airtight.
      • Apply a small amount of liquid detergent to the inner tube
      • Heat the end of the soft outer tube in hot (not boiling) water to make the tube more pliable
      • Push the two tubes together with at least the minimum overlap as shown
      • The outer tube will shrink and the detergent will dry to make a 'glued' but not permanent connection
      • Attach the corner pads per the illustration.


      Sold Out

      Back to the top