0 Cart
Added to Cart
    You have items in your cart
    You have 1 item in your cart
    Total
    Check Out Continue Shopping

    Water supply need not be shut off for this repair. Straight copper tube, barbed plastic tube and brass nut are not used for this repair.

    Disassemble

    • Pull hose from barbed check valve housing - cut black hose if necessary.
    • Remove plastic tube from flared copper tube.
    • Remove flared copper tube from hose.
    • Lift wand and remove hose from hose guide.
    • Unscrew handle nut - if pliers are required, pad jaws with a cloth to prevent scratches.
    • Slide handle completely off hose.
    • Allow red button to drop out.

    Reassemble Handle and Spray Tube

    • Slide handle onto new hose with large hose segment toward button hole.
    • Rotate handle and hose so that button hole is down.
    • Drop button into button hole.
    • Slide handle over venturi - spring side of venturi MUST be toward button.
    • Attach spray tube assembly - hand tighten the nut.
    • Adjust direction of spray to desired position by rotating spray tube assembly.
    • Tighten nut just firmly enough to hold spray tube in desired position.

    Attach Hose

    • Insert hose down through hose guide and seat wand in hose guide.
    • Insert small end of 'U' shaped flared copper tube into small hose section approx 3/4" - it will be helpful to lightly apply dish detergent to copper tube before insertion.
    • Press plastic tube over flared copper tube.
    • Insert barbed end of check valve housing, to shoulder, into large hose section - it will be helpful to lightly apply dish detergent to barbed area before insertion.
    • Make certain check valve housing threads have not been loosened during repair.
    Back to the top